ami-cpctools-mos 0.46

Short:        Ami-CPC tools
Author:       Ludovic DePlanque, Morphos port by Fabrizio "Lanch" Bartoloni
Uploader:     lanch tiscali it (Fabrizio Bartoloni)
Type:         misc/emu
Version:      0.46
Architecture: ppc-morphos

Note from porting author: Sorry I didn't manage to compile DZ80.C, luckily
there are way too many other Z80 disassemblers out there on Aminet.


 AMI-CPC is given with some tools :

    - Cpc2Cpe :         Allows to convert an old diskette file from AMI-CPC
                        (.CPC) to a diskette file usable with  CPE . 
                        It's a CLI command. An ASL requester allows to select
                        the .CPC source file, the file created's name is
                        always : drivea.dat.

    - Cpc2dsk :         Allows to convert an old diskette file from AMI-CPC
                        (.CPC) to a diskette file in the .DSK format.
                        It's a CLI command. An ASL requester allows to select
                        the .CPC source file, the file created's name is the
                        same that the original .CPC file, with it's extension
                        changed to .DSK.

    - Cpc2Emucpc :      Allows to convert an old diskette file from AMI-CPC
                        (.CPC) to a diskette file usable with  EmuCPC .
                        It's a CLI command. An ASL requester allows to select
                        the .CPC source file, the file created's name is the
                        same that the original .CPC file, with it's extension
                        changed to .EMUCPC.

    - CreeDisk :        Create an empty diskette in the .DSK format.
                        It's a CLI command. WARNING : the diskette created's
                        name is always DISC.DSK, and if a file of this name
                        exists, it will be erased by using this command.

    - DZ80 :            Allow to dissassemble a Z80 binary file.
                        It's a CLI command. It's need two arguments :
                        - the name of the source file,
                        - the start adress for dissassembling. This adress
                          can be type in decimal, or in hexadecimal, if typing
                          the '$' character.
                        Some options allows to put blank lines after some Z80
                        instructions. To obtain the list of theses options, 
                        just type under the CLI :
                        "DZ80", without any arguments.
                        The dissassembling output is sent on the OutPut() of
                        the dos.library. So you may redirect the output in a
                        file.

                        Example of utilisation :
                        "DZ80 Sapiens.bin $300 >sapiens.asm"