Xtsh14

Short:        Telserial Device 1.40 Install for Xeno
Author:       X-Team Development
Uploader:     cgfx xenolink computek net
Type:         comm/xeno
Architecture: m68k-amigaos


      TELSERIAL DEVICE 1.40 INSTALLATION FOR XENOLINK BBS


Attention this is what you need to set up telser.device
with Xenolink BBS. I have fully tested this with 6 nodes
and it works fine.

Note the problem Brendan was getting with the menus getting mangeled
I also was getting and I believe this has to do with Term and not
Xenolink as I have checked the Ansi ver well

Note Xenolink Screen Ansi is Perfect
Same time The Ansi/ascii in the menu text is perfect

if you telnet in from a shell everything is perfect.
but with term there is some small artifacting with the ansi/ascii

So I conclude the problem is within Term and not in Xeno or Telser

Note to setup 

1. Install telser.device 1.40
2. copy the file from the enclosed db into your amitcp:db
3. addon the service line and inet.config lines from the 
   service.addon and inet.config.addon if it already isn't done by
   the telser installer
4. Edit your Xconfig for your telnet node to match the sample
   node.config enclosed.

and you should be set:

CYA,


 X-Team Development
    Jack Boling

mailto://cgfx@xenolink.computek.net
http://www.xenolink.computek.net
ftp://ftp.xenolink.computek.net
telnet://bbs.xenolink.computek.net

snail://PO Box 560831 The Colony, Tx 75056 USA